Cutting oil storage
1, barrels of cutting oil should be stored in the warehouse, if you need to be placed in the outdoors, you must use waterproof canvas to cover the drum, to prevent the rain from entering the drum, if the rain enters the barrel, easy to make the cutting oil emulsification deterioration.
2, has opened the lid of the drum must be stored in the warehouse, the warehouse should pay attention to ventilation and keep dry, the temperature will affect the performance of the cutting fluid, should not be stored in too hot place for a long time.
3, the cutting oil barrel mouth is large, the cap is opened and used immediately after the barrel cover tightly to prevent dirt and water infiltration.
4, the barrel lying best, the barrel ends with wooden wedge wedge tight, to prevent rolling. If you have to put the drum straight, invert the drum so that the lid is down. Or slightly tilt the barrel, so as to avoid rainwater over the barrel surface and into the barrel.
5, water has a negative impact on any lubricant, no matter how good the seal of the barrel lid, due to changes in temperature day and night, will trigger the thermal expansion and contraction of the air inside the barrel, expansion and contraction caused by the pressure imbalance between the barrel and the barrel, such as water on the lid, the water will be absorbed into the barrel, contaminating the cutting oil.
6, the temperature of the cutting oil has a greater impact, long-term exposure to the sun outside, can make the cutting oil in the oil component separation, so it is better to store indoors, the end of the barrel lid up vertical.
Cutting oil precautions
1,Stored oils need to keep the barrel clean and clearly labeled.
2,Keep the warehouse floor clean to facilitate timely detection of oil leakage.
3,When the oil is out of the warehouse, it should follow the first-in-first-out.
4,No mixing with other oils.
5, cutting oil for the new liquid, should be the original liquid clean up and then change the new liquid.
